مولتی متر دیجیتال ریشاب Rishabh مدل RISH Mit 30

Insulation resistance measurement up to 3G Ohm  with Test voltages selection: 50 V, 100V, 250V, 500V and 1000V.

Measuring principal employed permits the measurement of rout mean square value (TRMS) OF AC quantities and mixed quantities (AC and DC) regardless of wave form.

Current measurement up to 300A with clip-on sensor having ratio 1mV/10mA.

By pressing min/max button instrument will start recording minimum and maximum readings.

Temperatures from -200 to 800 ºC using pt100 and pt 1000 sensors.

In order to save the power of the Batteries, the meter will automatically shut OFF if it detects no activity for 10 minutes.

This permits resting for short circuit and open circuit. In addition to the display, a facility of sound signal is available.

In AUTO ranging mode the instrument automatically selects the range with best resolution depending on the applied input. In MANUAL ranging mode range is user selectable using MAN key.

When measuring DC quantities, also negative values are shown on the analog scale so that variations of the measured value can be observed at the Zero point.

Instrument: Ip50 For terminals : IP20 as per IEC60529

۱۰۰۰ V CAT II/600V CAT III as per International Safety standard IEC 61010-1- 2001 and IEC 61557.

The display shows “FUSE” in case of blown fuse.

The automatic terminal blocking system prevents incorrect connection of test lead and incorrect selection of measurement quantity, which provide safety to the user.

The multimeters are fitted with a serial RS-232 C interface via which the measured values can be transmitted to a PC. These values, electrically isolated, are transmitted to the attachable interface adaptor with infrared light through the case.

Analog scale that updates at the rate 20 times/sec to observe fluctuations in input.

In this mode, AUTO POWER OFF is disabled.

By pressing DATA HOLD button, reading on the display can be latched for Hands free operation.

For Low ohm measurement, the lead resistance can be compensated by pressing the shift key (Yellow Key)

Null zero connection for capacitance. For nF range, stray capacitance can be compensated by shift key (Yellow Key)

For testing diode and transistors, diode measurement function is available.

For clear visibility in dark conditions, RISH MIT 30 is featured with backlit.